DEBI BAKER I am searching up the greenskin products. My comprehension of ditra is that it's not excellent for the smaller mosaics items ? How is plywood substrate attached towards the tongue and groove boards ? Screws of wht form and at which length ? Thanks for the recommendation
Tape the seams. Include the seams with fiberglass seam tape. Fill in and clean with thinset mortar. Enable dry thoroughly prior to laying tile.
Just desired to explain the substructure and assure which the discussion proceeds on emphasis with solution.
I was not informed I required to set thinset down before the backerboard. I made use of hardi screws (possibly much more than needed), but it will be a problem on employing thinset ahead of the hardi board was set into place?
share share on twitter share on facebook e-mail link Dct2156 likes this.
Maury P Vargas Ok your respond to offers me self-assurance, to ensure that’s perfect. Thanks. I assume one hundred screws for every hardi Seems Alright? And around the again of my Rock-On 2-1/four†inch screws it says it has got to go the many way via on plywood for “optimum general performance†does that sound like it? I designed a test wherever I screw in three/4s†onto 1†ply and one other all of the way by and made an effort to leverage it Together with the hammer claw and it seemed like the latter did greater in “upward†rigidity, each eventually unsuccessful as well as screw did not give, neither it misplaced friction coefficient amongst the Hello-Lo trademark threads, this means it didn’t slide out like on regular wood, but as an alternative the ply layers crunched and unglued just like a chocolate waffer cookie.
In which the board ought to go all-around irregular obstructions, such as plumbing pipes, toilets, etc., attract a template on contractor's paper, eliminate the template with scissors, then transfer the pattern towards the cement board with a pencil.
If every thing is butted tight as well as your wall expands in to the space guess what occurs. That’s correct, your Canine may burst into flames and not a soul would like that! It may even result in your floor to pop loose And maybe ‘tent’ or peak with the seams.
The joints in backerboards must be staggered. that just means that none of the seams need to line up over the place and no 4 corners needs to be placed together. By staggering the seams you incorporate toughness into the set up by simply not acquiring a big weak position while in the substrate.
The ramp is created to go from a particular peak, up and about into your shower pan installed on the identical Preliminary peak. So you do not want diverse heights within and outside from the shower. And Sure, you'd install the plywood first, then the partitions, then the shower pan.
Quit hovering to collapse... Simply click to break down... Hover to develop... Click on to broaden... share share on twitter share on facebook e mail url
Roger Yes, typical deck mud. No barrier or wire, but place thinset down very first to bond the new mud on the outdated.
But I'm certainly check here not about to argue with any person over it...nor am I going to return and rip out any of the myriad tile & marble installations I have finished on floors, countertops, walls, showers, etcetera., in 5 diverse residences during the last 4 many years. Rick Â
Cease hovering to collapse... Click to collapse... Hover to expand... Click to extend... share share on twitter share on Fb e mail url